About Each Function; F1. Fine Tuning Of The Pitch - Yamaha Clavinova CLP-100 Owner's Manual

Detailed Settings – [FUNCTION]

About Each Function

F1. Fine Tuning of the Pitch

You can fine tune the pitch of the entire instrument.
This function is useful when you play the Clavinova
along with other instruments or CD music.
1. Engage the Function mode and select
2. Use the [–/NO] and [+/YES] buttons to lower or
raise the pitch of the A3 key in approximately
0.2 Hz increments.
The value appears two-digit number and one decimal
place.
Ex. 440.2Hz is shown as 40.2 on the display.
Display
Hz (Hertz):
This unit of measurement refers to the frequency of a sound and
represents the number of times a sound wave vibrates in a second.
You can also use the keyboard to set the pitch (in any mode
other than Function mode).
To tune up (in about 0.2Hz steps): Hold the A -1, B -1 and C0
keys (three white keys at the left end) simultaneously and press
any key between C3 and B3.
To tune down (in about 0.2Hz steps): Hold the A -1, B -1 and
C#0 keys (two white keys and a black key) simultaneously and
press any key between C3 and B3.
To restore standard pitch: Hold the A -1,B -1, C0 and C#0
(three white keys and a black key) simultaneously and press any
key between C3 and B3.
Each key has a note name; for example, the lowest (farthest left)
key on the keyboard corresponds to A -1, and the highest
(farthest right) key to C7.
During the procedure described above, the display indicates a
value in Hz <
returns to the previous indication.
62
CLP-370/340/330, CLP-S308/S306 Owner's Manual
Value
440.0
Setting range:
427.0 – 453.0 (Hz)
440.2
440.4 Normal setting:
440.0 (Hz)
440.6
440.8
TERMINOLOGY
NOTE
... >. After the procedure, the display
You can also tune in about 1Hz steps (in any mode other
than Function mode).
To tune down or up, respectively, in approximately 1 Hz
increments: Hold the A -1, B -1 and C0 keys (three white keys at
the left end) or A -1, B -1 and C#0 keys (two white keys and a
black key) simultaneously and press the [–/NO] or [+/YES] button.
To restore standard pitch: Hold the A -1, B -1 and C0 keys
.
(three white keys at the left end) or A -1, B -1 and C#0 keys (two
white keys and a black key) simultaneously and press the [–/NO]
[+/YES] buttons simultaneously.
C#0
A#-1
C0
B -1
A -1
During the procedure described above, the display indicates a
value in Hz <
returns to the previous indication.
NOTE
C3
... >. After the procedure, the display
B3