Yamaha Clavinova CLP-100 Owner's Manual page 88

CLP-S308/S306: Keyboard Stand Assembly
1.
Attach D to E and F.
F
1-2
1-1
Attach D to E and F by using four long screws
(6 x 20 mm).
1-2
Secure D from the rear using two long screws
(6 x 20 mm).
1-3
Remove the twist tie from the folded pedal cord.
Do not remove the twist tie that is located next to
the hole.
2.
Attach B.
2-1
Insert B between E and F as shown in the illustration.
2-2
Align and attach B to the front side of D, E and F.
F
2-3
Temporarily secure B by finger-tighening four
long screws (6 x 20mm).
* Insert four screws into the larger holes (all four
holes) on the brackets.
2-4
Secure B using a thin screw (4 x 14 mm).
* Insert the screw into the smaller hole on the
bracket.
2-3
88
CLP-370/340/330, CLP-S308/S306 Owner's Manual
1-1
1-3
E
D
2-1
2-2
B
E
D
2-4
3.
Mount A.
3-1
Place your hands at least 15 cm from either end
of A to mount it.
3-2
Position A so that the stopper-wood on the rear
side of the bottom of A will be located behind the
front panel, then slide A slowly toward the rear.
A
3-1
3-2
CAUTION
Be extra careful not to drop or let your fingers be pinched by the
main unit.
CAUTION
Do not hold the keyboard in any position other than the posi-
tion shown in the illustration.
4.
Secure A.
4-1
Secure A from the rear using two short screws
(6 x 16 mm).
4-2
Secure A from the rear using two thin screws
(4 x 14 mm).
4-3
Secure A from the front using four short screws
(6 x 16mm).
4-2
A
4-1
4-4
Firmly tighten the screws you temporarily
fastened on B in steps 2-3 above.
4-4
4-3