Meter Section - Yamaha DIGITAL MIXING STUDIO N12 Owner's Manual

Meter section

n12
3 4 5
1
2
)
@
1 Microphone
Only
This is a built-in talkback microphone.
2 [SOLO LEVEL] control
This control adjusts the SOLO L/R bus output level. The
adjustable range is from –∞ to +6 dB. The "▼" position
corresponds to the nominal output level (0 dB).
3 [DAW TO AUX] control
This control adjusts the level of the signal routed
from the DAW AUX output (n12= DAW IN 15/16, n8=
DAW IN 11/12) to the AUX buses. The "▼" position
corresponds to the nominal output level (0 dB).
4 [AUX LEVEL] control
Adjusts the AUX OUT signal level (page 21). The "▼"
position corresponds to the nominal output level (0 dB).
While you are using the Monitor Remote function
NOTE
(page 33), signals that pass through the DAW will be
directly routed to the AUX bus.
5 AUX PHONES jack
This headphone connector outputs the AUX bus
signal. Use this connector to send a monitor signal
to the musicians. The output level at this jack can be
adjusted independently of the AUX OUT jacks.
6 [AUX PHONES] control
This control adjusts the output level at the AUX
PHONES jack. The "▼" position corresponds to the
nominal output level (0 dB).
7 C-R PHONES jack
This headphone jack outputs the control room
signal. The output level at this jack can be adjusted
independently from that of the C-R OUT jacks.
8 [C-R PHONES] control
This control adjusts the output level at the C-R
PHONES jack. The "▼" position corresponds to the
nominal output level (0 dB).
6
7
8
9
!
Only
Only
n8
3
)
9 CUBASE READY indicator
This indicator lights up when the mixer is ready to be
operated with Cubase 5/Cubase 4/Cubase Studio 5/
Cubase Studio 4/Cubase Essential 5/Cubase
Essential 4/Cubase AI 5/Cubase AI 4; that is, when
the computer is connected to the n8/n12 and
Cubase is linked to the mixer correctly.
) MASTER LEVEL METER
■ n12
This meter indicates the level of the STEREO/REC/AUX
bus signals, or the output level at the C-R OUT jack. To
switch the meter view, use the [METER SELECT] switch
!
( ). Depending on the setting of the [METER SELECT]
switch, the meter indication will change as follows:
[METER
SELECT] Meter A
switch
C-R OUT
C-R* jacks A
(L/R)
STEREO
BUS
bus
* Surround channels are indicated in parentheses.
■ n8
This meter indicates the output level at the C-R OUT
jacks.
! [METER SELECT] switch
This switch determines which signal will be indicated
via the MASTER LEVEL METER. Pressing the switch
will toggle between C-R (C-R OUT jacks) and BUS
(STEREO/REC/AUX bus).
@ [INPUT METER] switch
This switch selects the signal whose level is
indicated on the input meter (page 15) in the
Channel Control section. Pressing the switch
repeatedly toggles between PRE (pre-fader) and
POST (post-fader).
Front and Rear Panels
5 6 7
8
9
Meter B Meter C
C-R OUT C-R OUT
jacks B jacks C
(C/SW) (LS/RS)
REC bus AUX bus
Only
Only
Owner's Manual
17