Meter Select Section; Meter Bridge - Yamaha MC 24/12 Owner's Manual

METER SELECT section

You can select the signal source to be displayed in the Meter bridge section.
A
Source select switch
This switch enables you to select the signal source to be displayed on
the MATRIX (PFL•AFL/TAPE) meter (Meter bridge
corner of the level meter.
When the switch is set to PFL-AFL/TAPE (
The meter indicates either the PFL/AFL bus output level or the input
level of the signals sent from the TAPE IN jacks, depending on the
setting of the Monitor source select switch in the
C-R MONI section.
When the switch is set to MATRIX (
The meter indicates the output level of Matrix 1 and 2.

Meter bridge

This peak level meter indicates the output level of the MIX buses, ST bus, Matrixes 1/2, PFL
bus, and AFL bus, and the level of the signal input from the TAPE IN jacks.
PEAK
+8
+5
+3
+1
0
–1
–3
–5
–7
–10
–15
–20
M1
A
M1–M10 meters
These meters indicate the output level of MIX OUT 1–10.
B
ST1 meters
These meters indicate the output level of ST1 OUT.
C
MATRIX (PFL•AFL/TAPE) meters
These meters indicate the PFL/AFL bus level, input level of signals sent from the TAPE IN jacks,
or the output level of Matrixes 1/2, depending on the selection made in the METER SELECT
section.
D
POWER indicator
When the power to the MC32/12 (or MC24/12) is turned on, this indicator lights up.
E
PHANTOM indicator
This indicator lights up when any of the phantom power supplies (see page 16, rear panel
are turned on.
1
M2 M3 M4 M5 M6 M7 M8 M9 M10
METER SELECT section
3
) in the right
1
)
)
2 3 4
PEAK PEAK
+8 +8
POWER
+5 +5
+3 +3
+1 +1
0 0
–1 –1
–3 –3
–5 –5
–7 –7
–10 –10
–15 –15
–20 –20
L R 1 2
PHANTOM
ST1 MATRIX
L R
PFL•AFL / TAPE
MC32/12, MC24/12—Owner's Manual
15
PFL•AFL/TAPE
MATRIX
METER SELECT
5
4
)