Front And Rear Panels; Channel Control Section - Yamaha DIGITAL MIXING STUDIO N12 Owner's Manual

Front and Rear Panels

Channel Control section

1
4
2
5
3
7
8
9
) )
! !
@
#
$
^
&
*
%
1 [GAIN] control
This control adjusts the input signal level from the input
jacks (sensitivity). The adjustable range on each
monaural channel varies depending on the on/off status
of the [PAD] switch (
Monaural input channel
[PAD] switch is
on (
[PAD] switch is
off (
6
Stereo input channel
The level can be adjusted between –26 dB and +4 dB.
To achieve a quality sound with a good S/N ratio and
a wide dynamic range, set this control as high as
possible without allowing the OVER LED (see
page 15) to light.
2 [PAD] switch
This switch turns each channel pad on and off.
When it is turned on (
input jacks is attenuated by 26 dB. Turn the switch
off (
device with a low input level to the corresponding
monaural channel. Turn it on (
connect a synthesizer or other line-level instruments.
3
This switch toggles the high pass filter on or off.
When the switch is turned on (
filter cuts frequencies below 80 Hz of the signal from
the input jacks.
4 PHANTOM [+48V] switch
This switch toggles phantom power for condenser
microphones on and off. If you are connecting
condenser microphones to the XLR-type INPUT A
jacks on the rear panel, turn the switch on (
(The switch LED lights up.)
Each phantom switch turns the phantom power on and
off for four channels simultaneously. (Channels 1-4 and
channels 5-8 on the n12, and channels 1-4 on the n8).
NOTE
n12
Front and Rear Panels
2
).
The level can be adjusted between
). –34 dB and +10 dB.
The level can be adjusted between
). –60 dB and –16 dB.
), the input signal from the
) when you connect a microphone or other
switch (high pass filter)
When the switch is turned on, phantom power DC
+48V will be supplied to Pin 2 and Pin 3 of the
corresponding XLR-type INPUT A jacks.
) when you
), the high pass
).
13
Owner's Manual