Yamaha EMX-120CD Owner's Manual page 49

HOW TO USE THE BUILT-IN TIMER
STANDBY/ON HOUR
CD CHANGER RECEIVER EMX–120CD
PROGRAM
STANDBY/ON
ECHO MUSIC ECHO
KARAOKE MEMORY
PHONES
DISPLAY MEMORY AUTO/MAN'L
TIME ADJ TIMER
DISPLAY TIME ADJ
CD
1 2
1 2
6 7
6 7
A B
TIME PROG
MODE
DISC SKIP
CD TUNER
CENTER/REAR
TEST
/DELAY
ECHO
LEVEL
STANDBY/ON
SLEEP
STANDBY/ON
MIN
A/B/C/D/E PRESET/TUNING/BAND
DISC
OPEN/CLOSE CHANGE
DISC 1 DISC 2 DISC 3
INPUT SELECTOR VOLUME
CD TUNER
VCR•LD/TV•CD•TAPE/MD•TUNER
MIC TONE MIC MIC MIXING
REPEAT TIME INPUT TRIM
HOUR MIN
NORMAL SOFT MIN MAX
TIMER
TUNER
3 4 5
3 4 5
8 PRESET
8 9 0
C D E
+
I0
REPEAT RANDOM OPEN/CLOSE
STOP PLAY/PAUSE
INPUT
FLAT
KARAOKE MUSIC PROGRAM
DISPLAY
DISPLAY
VOLUME
ON TIME/time setting mode
["ON TIME" appears on the display, and soon it is
changed to a time setting mode.]
Set to the time when you want to begin the timer play
by using the HOUR button and the MIN button.
OFF TIME/time setting mode
["OFF TIME" appears on the display, and soon it is
changed to a time setting mode.]
If necessary, set to the time when you want to finish
the timer play (to turn this unit into the standby mode)
by using the HOUR button and the MIN button. Even
if you do not set the time, it has already been set so
that the timer play finishes after 1 hour.
Note
The TIMER button functions also in the time (ON TIME or
OFF TIME) setting mode. (However, it also turns this unit
into the standby mode.)
3
Press the TIMER button to complete the timer play
setting. (This unit turns into the standby mode.) If you will
still use this unit, press the STANDBY/ON switch to turn
on this unit.
Note
If you continue using this unit after a timer play setting is
made, the source set for the timer play will begin playing
when the time comes in place of the source played at that
time.
To cancel the timer play setting
After the timer play is finished (while the current time is
displayed), press the TIMER button so that "TIMER" goes out
from the display.
If you do not cancel the timer play setting, this unit will turn
on at the same time every day, so it can be used as an
alarm.
* Unless the AC supply lead is unplugged or there is a
power failure for more than 5 minutes, the time set on the
timer will be retained until it is reset.
How to make time setting in the ON TIME or OFF
TIME mode
For the hour:
Press the HOUR button to change the hour to a higher value.
Press and hold to change continuously.
For the minute:
Use the MIN button and operate it in the same way as you do
to change the hour.
Note
You can also change the hour (or the minute) to a lower
value by pressing the HOUR button (or the MIN button) with
the TIME ADJ button pressed and held.
E-41