Yamaha CDX-393MKII Owner's Manual page 16

L Manual tape-programming
For recording tracks in any desired order onto a tape.
4
SYNCHRO
SPACE
7
1
Follow steps 1 – 4 on page 15.
2
PROG
The track numbers you can program flash.
3
Select the track numbers to be recorded on side A in
any desired order.
The selected track numbers stop flashing and remain lit. If
a track is too long to fit on the remaining portion of side A,
the number stops flashing and disappears. You can not
program a number that stops flashing and disappears.
4
When track selection for side A is finished, press the
TAPE button.
TAPE
A pause is inserted.
16
OPEN/
DIMMER TIME CLOSE
2
PEAK TAPE CLEAR PROG
1 2 3
INDEX
+
4 5 6 I0
3, 5
7 8 9 0
REPEAT RANDOM
SEARCH
– +
OUTPUT LEVEL SKIP
STOP PAUSE PLAY 6, 7
PROGRAM
A TOTAL
REMAIN
1 2 3 4 5 6 7 8 9 10 11 12
1 2 3
+
4 5 6 I0
7 8 9 0
PROGRAM
B TOTAL
REMAIN
2 3 5 6 7 9 11
5
Select the track numbers to be recorded on side B in
any desired order.
1
4
7
6
Begin recording on the tape deck and press the PLAY
button on this unit at the same time.
7
The unit will pause at the end of side A of the tape.
Turn the tape over to side B, resume recording and, at
the same time, press the PLAY or PAUSE button on this
unit.
Notes
• If, in step 3 or 5, "E rr" appears on the display, the track
number just selected cannot be programmed because there
is not enough time remaining on the tape. However, at this
time, if any other track number is flashing continuously on the
display, you can program it instead of the unprogrammable
one.
• In step 3 or 5, each time a selection is made, the track number
and the tape's remaining time will be displayed, and then the
display will change to indicate the next program number.
• You can use "CD SYNCHRONIZED RECORDING" if you
have a YAMAHA tape deck with this function. In step 6 and 7,
press the SYNCHRO button then press the PLAY button on
this unit's remote control transmitter. Recording automatically
begins (for details, refer to page 19.)
• To check, cancel or correct program data, refer to page 14.
* In checking the program data, note that "Pu" appears
between track numbers for side A and side B.
• A maximum of 25 tracks can be programed. If you insert a
pause in your program, it is counted as one track.
• This function can be used to program up to track number 24.
If the disc has more than 24 tracks, track number 25 and
thereafter can not be programmed.
2 3
+
5 6 I0
8 9 0