Changing Brightness Of The Display - Yamaha 502 Owner's Manual

Changing brightness of the display

If desired, you can change brightness of the display
in three degrees by pressing the DIMMER button.
CDC-902 only
Adjusting the level of signals output into an
amplifier, etc.
You can adjust the level of sound signals output from the LINE
OUT terminals on the rear panel into an amplifier, etc. as you
prefer by using the OUTPUT LEVEL button.
–
OUTPUT LEVEL
* When the DIGITAL AUDIO OUT (OPTICAL) terminal is used
for the connection, set the level of output signals to max.
* The level of output signals can be checked on the display.
12
OUTPUT LEVEL
+
or
–
(On the front panel)
DIMMER
CDC-902 only
When you listen with headphones
Connect the headphones to the PHONES jack and adjust the
volume by using the OUTPUT LEVEL button.
* Note that the use of the OUTPUT LEVEL button will also
vary the level of the signal output to an amplifier, etc.
+
Normal illumination
Slightly dim
Dim
PHONES