Random Sequential Tape Programming - Yamaha 502 Owner's Manual

Display information during programming
1 2 3 4 5 6 7 8 9 10
1 2 3 4 5 6 7 8 9 10

Random sequential tape programming

The unit will automatically program tracks on a disc in random sequential order for recording to tape.
1
Follow step 1 – 5 on page 18.
2
* The unit will automatically program tracks for side A and
side B separately considering the tape's total time.
3
Begin recording on the tape deck and press the PLAY
button on this unit at the same time.
4
The unit will pause at the end of side A of the tape.
Turn the tape over to side B. Resume recording and,
at the same time, press the PLAY or PAUSE button on
this unit.
20
PROG
TOTAL
REMAIN
PROG
TOTAL
REMAIN
SYNCHRO
1
4
7
DISC SCAN
DISC SKIP
4
–
OUTPUT LEVEL
STOP
RANDOM
Shows the side of the tape and the program number for the
track to be programmed next.
Shows the selected disc and track number.
Shows the total remaining time on the side of the tape.
Programmed track numbers light up and programmable
track numbers among the unprogrammed ones flash on
and off.
* If "A-01" does not appear on the display after the PROG
button is pressed, press the TIME display mode-select
button.
* If, during programming, the TIME display mode-select button
is pressed, the program number display can be changed to
display the total remaining time on the side of the tape. To
return to the previous display, press the TIME display mode-
select button once again.
OPEN/
DIMMER TIME
CLOSE
TAPE CLEAR PROG
2 3
INDEX
+
5 6 I0
8 9 0
2
MODE REPEAT RANDOM
SEARCH
+
SKIP
PAUSE PLAY 3, 4
Notes
Because the programmed data changes every time the
RANDOM button is pressed, the amount of time remaining
at the end of the tape also changes accordingly.
If the tape's length is not enough, all tracks cannot be
programmed. In this case, exchange the tape for a longer
one.
In step 2, you can check the program data for side A and
side B.
1 3 5 7
Shows the number of programmed tracks for each side in
turn just after the automatic programming is finished, and
then it is replaced by the number of the first programmed
track for side A.
Shows the total time of programmed tracks for each side.
Shows the programmed track numbers for each side.
CD synchronized recording function can be used if your tape
deck is compatible with it.
In this case, in step 3 and 4, press the SYNCHRO button
and then press the PLAY button on this unit's remote control
transmitter. Recording automatically begins.
(For details, refer to page 17.)
PROG
TOTAL