Trimming Outboard Motor; Adjusting Trim Angle - Yamaha F200 Owner's Manual

ON
OFF
2. After stopping the engine, disconnect the
fuel line or close the fuel cock if there is a
fuel joint or a fuel cock on the boat.
3. Tighten the air vent screw on the fuel tank
cap (if equipped).
4. Remove the key if the boat will be left un-
attended.
NOTE:
The engine can also be stopped by pulling the
lanyard and removing the clip from the engine
stop switch, then turning the main switch to
" " (off).
EMU27861

Trimming outboard motor

The trim angle of the outboard motor helps
determine the position of the bow of the boat
in the water. Correct trim angle will help im-
prove performance and fuel economy while
reducing strain on the engine. Correct trim an-
gle depends upon the combination of boat,
ON
OFF
ZMU04600
engine, and propeller. Correct trim is also af-
fected by variables such as the load in the
boat, sea conditions, and running speed.
EWM00740
WARNING
Excessive trim for the operating condi-
tions (either trim up or trim down) can
cause boat instability and can make steer-
ing the boat more difficult. This increases
the possibility of an accident. If the boat
begins to feel unstable or is hard to steer,
slow down and/or readjust the trim angle.
1. Trim operating angle
EMU27882

Adjusting trim angle

Power trim and tilt models
EWM00751
WARNING
Be sure all people are clear of the out-
G
board motor when adjusting the tilt an-
gle, also be careful not to pinch any
body parts between the drive unit and
clamp bracket.
Use caution when trying a trim position
G
for the first time. Increase speed gradu-
ally and watch for any signs of instability
or control problems. Improper trim an-
gle can cause loss of control.
If equipped with a power trim and tilt
G
switch located on the bottom cowling,
use the switch only when the boat is at a
Operation
43