Changing Gear Oil - Yamaha F200 Owner's Manual

Maintenance
NOTE:
If the propeller nut does not align with the pro-
peller shaft hole after tightening to the speci-
fied torque, tighten the nut further to align it
with the hole.
EMU29282

Changing gear oil

EWM00800
WARNING
Be sure the outboard motor is securely
G
fastened to the transom or a stable
stand. You could be severely injured if
the outboard motor falls on you.
Never get under the lower unit while it is
G
tilted, even when the tilt support lever or
knob is locked. Severe injury could oc-
cur if the outboard motor accidentally
falls.
1. Tilt the outboard motor so that the gear oil
drain screw is at the lowest point possi-
ble.
2. Place a suitable container under the gear
case.
3. Remove the gear oil drain screw and gas-
ket.
66
1. Gear oil drain screw
2. Oil level plug
3. Gasket
NOTE:
If a magnetic gear oil drain screw is
G
equipped, remove all metal particles from
the screw before installing it.
Always use new gaskets. Do not reuse the
G
removed gaskets.
4. Remove the oil level plug and gasket to
allow the oil to drain completely.
ECM00710
CAUTION:
Inspect the used oil after it has been
drained. If the oil is milky, water is getting
into the gear case which can cause gear
damage. Consult a Yamaha dealer for re-
pair of the lower unit seals.
NOTE:
For disposal of used oil, consult your Yamaha
dealer.