Checking Tire Pressure; Checking Transmission Fluid Level - Kubota GR2000 Operator's Manual

42 PERIODIC SERVICE
.Checking Tire Pressure
A
WARNING
To avoid personal injury:
• Do not attempt to mount a tire on a rim. This
should be done by a qualified person with the
proper equipment.
• Always maintain the correct tire pressure.
Do not inflate tires above the recommended
pressure shown in the Operator's Manual.
• Inflation pressure in front tires rises quickly
when using compressed air.
A
CAUTION
Never operate machine with a loose rim, wheel, or
axle.
• Whenever bolts are loosened, retighten to
specified torque.
• Check all bolts frequently and keep them
tightened.
• Inflation Pressure
Though the inflation pressure is factory-set to the
prescribed level, it naturally drops slowly in the course of
time. Thus, check it everyday and inflate as necessary.
Tire sizes
Front
16 x 6.50 - 8,
4PR
Rear
23 x 10.50 - 12,
4PR
1 BDABARAPOO2A
(1) Ground
Recommended Inflation
Max. Pressure
200 kPa
(2.0 kgf/cm', 29 psi)
140 kPa
(1.4 kgf/cm', 20 psi)
(A) "INSUFFICIENT"
(B) "NORMAL"
(C) "EXCESSIVE"
.Checking Transmission Fluid Level
1. Park the machine on a flat surface, lower the
implement to the ground, shut off engine and remove
the key.
2. Raise the operator's seat.
3. To check the oil level, draw out the dipstick, wipe it
clean, replace it, and draw it out again. Check to see
that the oil level lies between the two notches.
If the level is too low, add new oil to the prescribed
level at the oil inlet.
(See "LUBRICANTS" in "MAINTENANCE" section.)
1 BDAHADAP065A
(1) Oil level dipstick
NOTE:
(A) Oil level is acceptable
within this range.
• Check the oil level of the transmission case with the
mower lifted up.
IMPORTANT:
• If oil level is low, do not run engine.