Table of Contents
Advertisement
7.19 Notes on the Hard Disk
Do not turn the machine OFF via the power switch. Turning the machine OFF via
the power switch may negatively impact the performance and life of the drive.
Make sure to use the Control Panel Power Switch on the operating console to turn
OFF the machine properly. For detailed instructions on shutting down the machine
properly, see the Introduction to the Machine e-Manual.
It is strongly recommended that the Administrator of the machine back up
important data, such as Inbox or Address Book contents, using the machine's
System Administrator mode periodically.
8.
Installation Review
This chapter describes the necessary number of technicians required to install the
machine properly, the time required to install the main unit and optional equipment,
and customer installation responsibilities.
8.1 Installation Time
The time required to install the imagePRESS 1125P depends on the options and
accessories to be installed, and the number of technicians performing the
installation. Customers should discuss the time requirements with their servicing
dealer and schedule the installation accordingly.
IMPORTANT
• Set up time may vary due to the following conditions:
- Forklift availability and its operator
- Narrow hallways, or a need to remove doors to enter rooms
- Uneven or damaged floors making leveling the equipment difficult and time
consuming
• With the aforementioned conditions in mind, installation of only the main unit can
take up to 2 hours. If accessories are included in the installation, the times in the
table below must be added.
Version 3
imagePRESS 1125P Customer Expectations Document
Page 46
Advertisement
Table of Contents
