Power Supply; Cable Connection; Water And Moisture - Graf AquaControl+ User Information

1.7

Power Supply

The equipment may only be operated with the operating voltage of 230V AC specified in
the user information.
A residual current circuit breaker (RCD) with a rated residual current not greater than
30mA must be provided, because it is a socket outlet circuit which is intended for use by
laypersons and for general use. The maximum permissible rated residual current for per-
sonal protection is 30mA.
For correct dimensioning of the residual current circuit breaker (RCD), the informa-
tion provided by the manufacturer of the pump you are using must be observed. A
residual current circuit breaker (RCD) of type B (universal current sensitive) is usually
sufficient. In some cases, however, a type F (mixed frequency sensitive) may also be
required.
Make sure to also observe the country-specific regulations.
1.8

Cable Connection

When installing the cable connections, the user needs to pay attention to the
safety regulations. Always pay attention to the connection to the protective earth
ground! Pay attention when connecting with other devices, that those have to be
of the same earth potential (same heavy current/voltage side).
1.9 Ventilation
The equipment must be installed in so that good ventilation to the device is ensured. Do
not put any covering objects on the device, such as newspapers, books or towels.

1.10 Water and Moisture

The device is not allowed to operate in close vicinity of electrical conductive liquids
or moist areas. It is not allowed to place any liquid things on the device or in the
nearby area of the device.
Attention: Danger of Electric Shocks!
6