Control Panel
While in Synth Mode, you can use the Control Panel to edit your Programs and save them for
later use. Each area of the Control Panel is described below.
To save your changes, please see Program Management > Saving Programs.
Main Page
Amp Controls
The controls described in the following sections are
available when viewing the Main Page.
Volume: Use this slider to raise or lower the Program's volume.
Important: This is different from EWI5000's Level Button, which
affects the volume of all Programs.
Pan: Use this knob to set the Program's panning in the stereo field.
Reverb: Use this slider to set the Program's Reverb Send level (the
same as on the Effects page). You can also set this by using
EWI5000's Reverb Knob.
Chorus: Use this slider to set the Program's Chorus Send level (the
same as on the Effects page). You can also set this by using
EWI5000's Chorus Knob.
Delay: Use this slider to set the Program's Delay Send level (the same
as on the Effects page). You can also set this by pressing and holding
EWI5000's Trans Button while turning its Bite Knob.
11