Trane BAYUVCLK001 Installer's Manual page 12

STEP 22. There are two yellow control wires in the UV accessory
that are only used with Series 8 air handlers. Connect these two
wires to the two yellow UV Light wires in Series 8 air handlers
as shown using the wire nuts provided. (Refer to air handler
wiring diagram .)
For all other air handlers stow these wires securely and leave them
unconnected.
NOTE: A BAYCC24VK01 can be installed for Series 8 Air Han-
dlers to extend the life of the lamp. This accessory kit will disable
the lamp during the heating season (kit is purchased separately).
STEP 23. Use the provided cable ties to secure all wires
STEP 24. Apply wiring diagram label to the inside of the coil com-
partment panel.
IMPORTANT: Make sure all wires are secured completely behind
the crossbar and below the coil to prevent wire damage when coil
panel is replaced.
STEP 25. Apply UV Hazard warning label to the outside of the coil
compartment panel. Place panels back on air handler.
12
Series 8 Air Handler Only
l L in e
n ta p
am
ri zo f L
H o m o
ib e
tt o
S cr B o
n g
3. ca ti
L o
ck et
B ra
-
18-GJ11D1-2