Trane BAYUVCLK001 Installer's Manual page 11

Note: There are two connecting harnesses for the lamps. The short
harness is for the right lamp. The longer harness is for the left
lamp.
STEP 17. Route the right hand lamp connector and ground wire har-
ness to the right hand lamp.
STEP 18. Place the ground wire on the stud. Place a factory supplied
nut on the ground stud and tighten it to secure the grounding wire
in place. Then place a second factory supplied nut onto the stud
and tighten in place also.
STEP 19. Support the lamp and place the pin connector on the lamp.
The connector is position sensitive and will slide on easily when
in the proper orientation.
STEP 20. Use one of the provided cable ties to secure the lamp to the
bracket. Loop the cable tie around the lamp bracket and through
the eyelet on the plug.
STEP 21. Follow the same process for the second lamp.
18-GJ11D1-2
Through eyelet
Ground
Nuts
Ground
Nuts
Cable tie
through
hole in
bracket
11