Menu Structure; Display Unit (Metric / Inch) - Helios EDR Installation And Operation Manual

Installation and Operating Specification EDR

7.3 Menu structure

100 Pa
Δp
Selection of the menu group (e.g. BASE SETUP) to the right through the ▼-key, to the
left through the ▲-key.
Youcangotothemenuitemsinthemenugroups (e.g. mode) by using the P key. Use the
arrow keys to move up and down within the menu group.
To make adjustments, press the P key after selecting the menu item. If the previously set
value starts to flash, it can be adjusted with the ▼ + ▲ keys and then saved with the P
key. To exit the menu without making any changes, use the "Esc" short-key, i.e., the
originally set values remain.
Example for Mode
INFO
P↓ ↑ Esc
100 Pa
Δp
▲ ▼
500 Pa
Setpoint 1
▲ ▼
Reprogramming Mode
1
4.01
Mode

7.4 Display unit (metric / inch)

The display can be switched between SI units (factory setting) and imperial (US) units
see BASE SETUP / Units.
Conversion factor Pressure: 1,0 in.wg = 254 Pa
L-BAL-E292-GB 1841 Index 001
Display after turning on the voltage supply.
Switch over between actual value display and "INFO" with
the key shortcut for Escape (Esc = ▼ + ▲).
2.01 (Factory setting)
▼
▲
SETTING
P↓ ↑ Esc
500 Pa
Setpoint 1
▲ ▼
500 Pa
Setpoint 2
▲ ▼
4.01
2 3
«4.01»
P
Mode
▼
▲
BASE SETUP
P↓ ↑ Esc
4.01
Mode
▲ ▼
1: metric
Units
▲ ▼
to 4.00 in "BASE SETUP"
4 5
«4.00»
▲
Mode
Part.-No.
9/15
Programming
INFO
6 7
4.00
P
Mode