Xerox DocuPrint 92C NPS Maintenance Guidance page 27

XEROX DOCUPRINT 92C NPS GUIDE TO PERFORMING ROUTINE MAINTENANCE
4. Determine if the fuser is cool.
Place your hand approximately 1 inch (25 mm) above the fuser
area.
If you feel heat, STOP, leave the fuser drawer out, and wait for
the fuser to cool. DO NOT touch the fuser while it is hot.
If you DO NOT feel heat, continue with the procedure.
Warning: Perform this task only when the fuser is cool.
!
Exercise care to prevent burns when working in this area. Do not
perform this task if the fuser is hot.
5. Put on gloves.
Warning: Fuser lubricant contains silicone that causes eye
!
irritation upon contact. Wash your hands with soap and water
after you finish this procedure.
FUSER LUBRICANT AND PRESSURE ROLL WIPER
Ä
Ä
4-5