Printing On Specialty Media - Xerox Phaser 5550 User Manual

2.
Insert the transparencies (long-edge feed preferred) into Tray 2, 3, 4, or 5.
Note:
Do not load paper above the fill line inside the tray.
3. Adjust the paper guides to the size of the transparencies.
4.
If prompted on the control panel, press the OK button to accept the paper size and type
that are shown. If you have changed the paper size or type, do the following:
a. Select
Change setup
b. Select
Transparency
c. Select the paper size, and then press the OK button to save your selection.
5. In the printer driver, select either Transparency as the paper type or the tray you loaded as
the paper source.
, and then press the OK button.
, and then press the OK button.
Phaser® 5550 Printer
4-37

Printing on Specialty Media

5550-143