Basic Settings Menu (Bsc) - WEG MMW03-CH User Manual

Menu Sub Menu 1
485
dIn
Set
dIn
CLr
Uer

3.4.1 Basic Settings Menu (bSc)

This is the menu item where you make the current transformer ratio, voltage transformer ratio and connection type
settings. Please see Table 3-3 for the menu tree and Section 5 for the factory default settings.
The calculated currents are multiplied by the current transformer ratio (Ctr) and the calculated voltages are multiplied
by the voltage transformer ratio (Utr) to be indicated on the displays and the modbus addresses.
If"stA"(3-phase, 4-wire connection type) was specified for the network connection setup, the initial menu is "Voltage
(Phase-Neutral)". This menu is displayed first when the device is energized.
If "dEL" (3-phase, 3-wire connection type) was specified for the network connection setup, the initial menu is
"Voltage (Phase-Phase)". This menu is displayed first when the device is energized.
Sub Menu 2 Sub Menu 3
bAU
Id
nOn
Prt
Eun
Odd
tYP
In1
dLY
Edg
In2
tYP
dLY
In2
Edg
OFF
All
Enr
Cnt
HI
LO
dEd
SEt
ALr
Tabela 3.3: SEt Menu Tree
Sub Menu 4
OFF
tr2
Cnt
run.
Digital input 1 detection delay time
Digital input 1 detection edge
rIS
FAL Detection in falling edge (Only valid for counter)
bot Detection in both edges (Only valid for counter)
OFF
tr2
Cnt
run.
Digital input 2 detection delay time
Digital input 2 detection edge
rIS
FAL Detection in falling edge (Only valid for counter)
bot Detection in both edges (Only valid for counter)
Reset the device to factory settings
Reset the setup to factory settings
Reset the alarm setup to factory settings
Firmware version information
Electronic Multimeter - MMW03-CH | 17
www.weg.net
Description
RS485 setup
Baud rate options
Slave ID setup
Parity check setup
Parity check off
Even parity
Odd parity
Digital input setup
Digital input 1 setup
Digital input 1 options
Off
Enable tariff 2
Enable counter
Enable Run Hour
Detection in rising edge
Digital input 2 setup
Digital input 2 options
Off
Enable tariff 2
Enable counter
Enable Run Hour
Detection in rising edge
Clear menu
Clear abort
Clear the energy counters
Clear the counters
Clear the max. values
Clear the min. values
Clear the demand values