Table of Contents
Advertisement
3.3 ENERGY METERS MENU (ENR)
The device have one tariff meter.
These tariffs are shown in "Enr" menu. Each tariff has import active, export active, import reactive and export
reactive meters.
„ Import Active Energy Meter (I.Ac)
„ Export Active Energy Meter (E.Ac)
„ Import Reactive Energy Meter (I.rE)
„ Export Reactive Energy Meter (E.rE)
3.3.1 Assigning Predefined Value for Energy Meters
ATTENTION!
Counters are displayed in the format xxx xxx xxx kWh / kVArh (See Fig. 3-3). All counters are reset at 999 999 999 kWh /
kVArh and then start over from zero.
In any meter menu, press and hold the right key for at least 2 seconds and the respective menu title starts blinking.
Using the right arrow key, move to the digit you want to change and enter the value using the up/down arrows.
When you are done entering the value, confirm using the left arrow key. Move on to the storage procedure to store
the changes you made. (See 3.6 Save Procedure).
ATTENTION!
If password protection is enabled, press and hold the right key for at least 2 sec to display the password authentication
page. Enter the password to proceed to the counter assignment.
3.4 SETTINGS MENU (SEt)
MMW03-CH setings is made in the SEt menu. Table 3-3 shows the Set menu tree.
ATTENTION!
The menu tree is based on the fully equipped variant model. Some of the menus may be missing in less equipped models.
PF
P
Q
S
THD
Dem
1
2
3
T
Hi
Lo
Figura 3.3: Import Active Energy Display
www.weg.net
Electronic Multimeter - MMW03-CH | 15
Advertisement
Table of Contents
