Switching Between Fahrenheit And Celsius; Rebooting Your Coolbot; Error Codes On Your Coolbot; Er" Flashes On My Coolbot Display - Store It Cold CoolBot Instruction Manual

SWITCHING BETWEEN FAHRENHEIT AND CELSIUS

This setting allows you to switch your CoolBot from displaying °F to °C
NOTE: The factory default temperature scale is in °F
To change the scale of the temperature display:
● Press the right arrow until the Mode Indicator Light is in the Program position (Program Mode).
Press the checkmark ✓ button 5 times. You'll see a blinking "P1".
●
● Press the right arrow once or until you see "P2" blinking on the display.
Press the checkmark ✓ button once to enter the "P2" menu. You'll see an "°F" blinking.
●
● Press the right arrow once or until you see a "°C" blinking on the display.
Press the checkmark ✓ button once to save the value.
●
● The display will go back to a "P2" blinking and after 20 seconds of inactivity, it will go back to the Room Mode.

REBOOTING YOUR COOLBOT

See page 13.

"Er" FLASHES ON MY COOLBOT DISPLAY

Er is a communication error with the Room Sensor.
The Room Mode Indicator Light flashes rapidly if you press the right arrow to move to the Fins Mode.
● Unplug the Room Sensor from the CoolBot.
● Inspect the cable for possible damages in the cord or on the tip. Inspect the port connection as well.
● Clean the plug end of the sensor (jack connector) with a cotton cloth and plug it back in the CoolBot port a
couple times making sure it goes all the way in. It should sit firm and snug- shouldn't wiggle or feel loose.
● If the error persists after 20 seconds, unplug the sensor from the Room port and switch ports with the Fins
Sensor by plugging the Room Sensor in the Fins port and the Fins Sensor in the Room port.
● If the "Er" message is gone and now you have a flashing "Ef" while the Fins Mode light blinks rapidly, then
your Room Sensor cable (currently plugged in the Fins port) is bad and needs replacement.
● Plug the Fins Sensor back into the Fins port.
● Discard your Room Sensor.
● "Er" will still show on the display (because there is nothing plugged in the Room port). That is all right.
The CoolBot can work with one (1) good sensor plugged in to the Fins port while your replacement sensor is
Since the CoolBot won't display the room temperature while running in the "Safety Mode," the Room temperature will
have to be monitored with the aid of an external thermometer.
To order a replacement sensor under warranty (1 year) please contact our support team at support@storeitcold.com.
To purchase new sensors please visit our parts page at:
Rev: 2020 – 3A

ERROR CODES ON YOUR COOLBOT

- SAFETY MODE-
being shipped. DO NOT plug anything in the Room port!
https://storeitcold.com/category-product/coolbot-parts/#
©2020 Store It Cold, LLC 11