Checks On Your Coolbot; My Heater Does Not Seem To Be Working; Temperature Sensors Calibration Test; The Coolbot Has No Lights And No Display - Store It Cold CoolBot Instruction Manual

MY HEATER DOES NOT SEEM TO BE WORKING

Checking the HEATER is very simple:
● Pull the HEATER out of the aluminum foil. Hold the red tip against the inside of your wrist with your fingers.
● Unplug the POWER to the CoolBot, then plug it back in. In ~5 seconds the Heater Activity Indicator light will
come on SOLID for about 20 seconds.
● The HEATER should get Warm/Hot within the first 10-30 seconds of the CoolBot being plugged in. If not,
unplug/plug the HEATER a couple times and repeat the test.
● If it STILL doesn't get warm contact us at
NOTE: During normal operation, the Heater light blinks and you may not feel the warmth.

TEMPERATURE SENSORS CALIBRATION TEST

Checking the Calibration of your sensors is very simple:
● Gently slip the Fins Sensor tip out of the fins of the A/C. Let the tip of the sensor hang right next to the tip of
your Room sensor cable.
● Allow 2 minutes for the sensor to adjust its temperature reading.
● Compare the Room temperature reading with the Fins temperature reading using the arrows to toggle back
and forth between the Room Mode and the Fins Mode.
● Your Room Sensor and your Fins Sensor should read within 3 degrees of each other. If one of the sensors is
more than 3 degrees away from the other, compare the readings against a calibrated external thermometer
and replace the faulty sensor.

THE COOLBOT HAS NO LIGHTS AND NO DISPLAY

1. Make sure that there is proper power supply to the outlet where the CoolBot is plugged in (120V).
2. If proper power is supplied and the CoolBot has no lights and no display the power supply needs replacement.
If this is an emergency, you can get a generic Mini-USB power supply rated at 5VDC / 1 amp (or higher amp)
until you get the original power supply shipped to you.
To order a replacement Power Supply under warranty (1 year) please contact us at
To purchase a new Heater please visit our parts page at:

DIRTY FINS

•
This is a very common problem! Dirty front fins drastically reduce cooling power and waste electricity. Clean
the fins 2 times a month.
•
For the inside coils use a plastic brush with bristles long enough to go all the way through the fins.
Depending on the make of your A/C, a dish brush or paintbrush might work well.
•
Use plain water. DO NOT use soap! Soap residue attracts more dirt!
•
Dunk bristles in water then swipe down the fins. Rinse the bristles in the water and repeat, working your
way across until all the fins have been brushed. Change out the water as needed if it gets murky.
•
A/C supply stores also sell "Foaming Coil Cleaner". This works great for the outside coil.
Rev: 2020 – 3A

CHECKS ON YOUR COOLBOT

support@storeitcold.com.
.
https://www.storeitcold.com/replacement-parts/

CHECKS ON YOUR A/C UNIT

©2020 Store It Cold, LLC
support@storeitcold.com.
14