Heater Delay Setting; Switching Between Fahrenheit And Celsius; Rebooting Your Coolbot - Store It Cold CoolBot Instruction Manual And Troubleshooting Manual

HEATER DELAY SETTING

This setting allows you to increase or decrease the defrost cycle time.
NOTE: The factory default Heater Delay setting is "d1"
If you are experiencing ice ups and the problem has not been solved by increasing your
Fins setting, then raise your Heater Delay setting.
95% of CoolBot installations work well with settings in the SHADED zone.
SETTING d0
To change the Heater Delay setting:
●
From the Room Mode position press the right arrow until the Mode indicator
light is in the Heater position (Heater Mode).
Press the checkmark ✓ button 3 times. The current Heater Delay setting will
●
blink on the display.
●
Press the right/left arrow to increase/decrease the value of the setting.
Press the checkmark ✓ button to save your new setting into memory.
●
●
The display will go back to the Heater Mode and after 20 seconds of inactivity,
it will go back to the Room Mode.

SWITCHING BETWEEN FAHRENHEIT AND CELSIUS

This setting allows you to switch your CoolBot from displaying °F to °C
NOTE: The factory default temperature scale is in °F
To change the scale of the temperature display:
●
Press the right arrow until the Mode indicator light is in the Program position
(Program Mode).
Press the checkmark ✓ button 5 times. You'll see a blinking "P1".
●
● Press the right arrow once or until you see "P2" blinking on the display.
Press the checkmark ✓ button once to enter the "P2" menu. You'll see an "°F"
●
blinking.
● Press the right arrow once or until you see a "°C" blinking on the display.
Press the checkmark ✓ button once to save the value.
●
● The display will go back to a "P2" blinking and after 20 seconds of inactivity, it
will go back to the Room Mode.

REBOOTING YOUR COOLBOT

This will restore the CoolBot to factory settings.
To reset the CoolBot back to factory default settings:
●
Press the right arrow until the Mode indicator light is in the Program position
(Program Mode).
Press the checkmark ✓ button 5 times. You'll see a blinking "P1."
●
Press the checkmark ✓ button again, it will read "n."
●
● Press the right arrow once or until the display reads "y."
Press the checkmark ✓ button and don't press anything else.
●
●
The display will go back to the Room Mode.
Rev: 2017 – 11A
d1 d2 d3 d4
©2017 Store It Cold, LLC
d5 d6 d7 d8 d9 30 60
12