Horizon Fitness BQ-150 Manual page 17

2. Operation Procedure
2-1 Binding Operation Procedure
5.
Adjust the clamper opening with the
clamper open button so that the opening is
about 5 mm wider than the thickness of
the book block.
6.
Place the book block into the clamper and
align it with the left side of the clamper.
The clamper close lamp will light.
7.
Close the clamper by pressing the clamper
close button.
NOTE
When the clamper is completely closed, the
light in the clamper close button goes out and
the start lamp lights.
8.
Press the start button.
- The clamper moves to the left. After it has
reached the left end of its travel, it returns
to the home position (above the nipper)
while applying glue to the spine of the
book block. Air is blown onto the spine of
the book for 15 sec., and then the lamp in
the clamper open button lights.
9.
Press clamper open button.
- The clamper opens, the light in the
clamper open button goes out, and the
reset lamp lights.
10.
Remove the book by lifting upward.
NOTE
- The nipper is reset automatically by remov-
ing the book.
When identical binding is to be done,
repeat steps 5 to 10 of the foregoing
procedures.
Roughening Cutter
Monitor Lamp
OFF
Roughening Cutter ON/OFF Switch
Clamper Close Button
Start Lamp
Start Button
12
ON
Clamper Open
Button
Reset Lamp