Xerox Trimmer Module SquareFold User Manual page 20

Problem solving
Fault code
E303 A top cover is open.
E304
E308 The Trimmer Waste Container is full or
E940 has a fault.
E941
E943 Booklet Tray on the SquareFold
Trimmer Module is full.
16
Possible cause Recommended solution
1. Open the Top Left and Right Covers of the SquareFold
Trimmer Module.
Close the SquareFold Trimmer Module Top Left and Right
2.
Covers.
If fault persists, power off/on the copier/printer.
3.
4.
If fault persists, call for service.
1. Pull open the container and empty any trimmer scraps from
it.
Reinsert the container into the SquareFold Trimmer Module.
2.
Ensure that the container is fully pushed in, and that the
3.
indicator light is not lit.
4. If fault persists, repeat Steps 1-3.
5. If fault persists, power off/on the copier/printer.
6. If fault persists, call for service.
1. Remove any booklets from the tray.
If fault persists, power off/on the copier/printer.
2.
If fault persists, call for service.
3.
SquareFold Trimmer User Guide