Wan Card Slot Module Leds - Cisco NM-1E2W Configuration Note

WAN Card Slot Module LEDs

Token Ring Pinout
Table 3 lists the pinout for the Token Ring port. Pins not listed are not connected.
Table 3
Pin
1
3
5
6
9
1. 600 mA maximum.
WAN Card Slot Module LEDs
Figure 16, Figure 17, and Figure 18 show the LEDs on each 2-slot network module.
All network modules have an enable LED. The enable LED indicates that the module has passed its
self-tests and is available to the router.
Ethernet Network Module LEDs
The 1E and 2E 2-slot network modules have two Ethernet LEDs. The ACT (activity) LED indicates
that the router is sending or receiving Ethernet transmissions. The LNK (link) LED indicates that the
Ethernet port is receiving the link integrity signal from the hub (10BaseT only).
Figure 16
1E
2W W1
14 WAN Card Slot Network Module Configuration Note
Token Ring Port Pinout (DB-9)
Signal
Receive
1
+5V
Transmit
Receive
Transmit
1-Ethernet 2-WAN Card Slot Network Module
Key for BRI WAN
interface cards
10BaseT AUI
port port
ETHERNET 0
LEDs
WO
AUI
EN
Enable
LED