Cisco NM-1E2W Configuration Note page 20

Configuring the LAN Interfaces
Step 5
Step 6
Step 7
Step 8
20 WAN Card Slot Network Module Configuration Note
The System Configuration Dialog prompts you to configure network interfaces. To
configure an Ethernet interface, press Return or enter yes when you reach a prompt
similar to this one, and then continue with Step 6:
Configuring interface Ethernet0/0:
Is this interface in use? [yes]:
To configure a Token Ring interface. press Return or enter yes when you reach a prompt
similar to this one, enter the ring speed, 4 or 16, and then continue with Step 6:
Configuring interface TokenRing1/0:
Is this interface in use? [yes]:
Tokenring ring speed (4 or 16) ? [16]:
Determine which protocols you want on the LAN interface and enter the appropriate
responses. (You must have previously enabled these protocols as part of global
configuration.) In the following example, the interface is being configured for IP,
AppleTalk, and IPX:
Configure IP on this interface? [yes]:
IP address for this interface: 172.16.74.3
Number of bits in subnet field [8]: 8
Class B network is 172.16.0.0, 8 subnet bits; mask is
255.255.255.0
Configure AppleTalk on this interface? [no]: yes
Extended AppleTalk network? [no]: yes
AppleTalk starting cable range [0]: 3
AppleTalk ending cable range [1]: 3
AppleTalk zone name [myzone]: ZZEth
AppleTalk additional zone name:
AppleTalk additional zone name:
Configure IPX on this interface? [no]: yes
IPX network number [1]: B005
If your router has more than one LAN interface, repeat Step 5 and Step 6 to configure the
next LAN interface.
The configuration you entered is displayed as a command script and you are asked if you
want to use it. If you enter no, the information you just entered is discarded and you can
begin the configuration again. If you enter yes, the configuration is saved in the startup
configuration:
Use this configuration? [yes/no]: yes
Building configuration...
Use the enabled mode 'configure' command to modify this configuration.
Press RETURN to get started!
The configuration is saved. If you added an interface, the router reboots in the new
configuration when you press Return.