Silvercrest SDB 2400 A1 Operating Instructions Manual page 65

Before the First Use
1) Fill the water tank with water (See "Filling with mains water").
2) Insert the plug into a mains power socket supplying an electrical current as
detailed on the rating plate.
3) Hold the steam iron horizontally.
4) Place the temperature regulator
5) Heat the steam iron up for several minutes at this highest setting.
6) Activate the steam blast
7) Then, to remove any production residues possibly remaining on the sole of
the iron 9, iron a piece of material that is no longer required.
Operation
Filling with mains water
Attention! Appliance Damage!
► Under no circumstances should you use water from the clothes dryer, scented
water, air-conditioning water or rain water for steam ironing. These waters
contain minerals, organic substances or particles that can lead to a spraying
out of the water, brown discharges and a premature aging of the appliance.
► Do not put any additives in the water tank. These can damage the appli-
ance!
1) Hold the steam iron at a slight angle.
2) Open the water fi ll opening
3) Using the measuring beaker
marking, but no further.
Should the mains water at your locality be rated as hard, it is recommended that
you mix the mains water with some distilled water. Otherwise, the jets for the
steam blast function could calcify (become blocked) prematurely.
To extend the optimal steam blast function, mix mains water with distilled water
as per the following table.
SDB 2400 A1
7 into the position "MAX".
3 button a few times.
for the water tank q.
w, fi ll the water tank with water to the "Max"
GB
MT
63