Advertisement
5. Push the start/stop switch (C) down to stop the
engine. The buzzer starts.
6. Open the rear cover and turn the battery switch (A).
The buzzer (B) stops.
Introduction
WARNING: Read and understand the safety
chapter before you do maintenance on the
product.
General product maintenance
Make sure that there are no fuel or oil leaks.
Clean the product.
Make sure that nuts and screws are tightened.
Do a check of the functions of the remote control and the
receiver (LH 804).
Examine the safety straps for damage. Replace if it is
necessary.
Examine the vibration damping units for damage.
Examine all rubber hoses and rubber elements for dam-
age. Replace if it is necessary.
Do a check of the hydraulic oil level.
Do a check of the battery.
Replace the oil in the eccentric element.
Replace the hydraulic oil and hydraulic oil filter.
O = Refer to the instructions in the engine manual
supplied by the engine manufacturer.
Engine maintenance
Do a check of the fuel level and the engine oil level.
Examine the air filter. Clean the air filter if it is necessary.
18
A
B
Maintenance
7. Push the stop button (A) to stop the remote control.
The LED indicator on the remote control goes off.
8. Put the remote control in the transport position
behind the rear cover. Lock the rear cover with a
padlock. This makes sure that the product cannot be
used by persons that are not approved.
Maintenance schedule
* = General maintenance done by the operator. The
instructions are not given in this operator's manual.
X = The instructions are given in this operator's manual.
Before use,
Weekly,
each 10 h
each 100 h
*
X
*
*
X
X
Before use,
After the
each 10 h
first 20 h
X
X
A
Monthly,
Yearly, each
each 250 h
500 h
X
X
X
X
X
X
X
X
X
Weekly,
Yearly, each
each 100 h
300 h
1177 - 001 - 02.04.2020
Advertisement
