Advertisement
5. Move and hold the joystick (A) on the remote control
away from center position.
C
6. Turn the start/stop button (B) clockwise to start the
remote control.
7. Push the button (C) for a minimum of 5 seconds.
The LED indicator on the remote control starts to
flash in green and yellow. The pairing operation is
also shown on the display.
8. Release the joystick. The RX indicator on the
receiver and the LED indicator on the remote control
has a green light.
a) If the RX and LED indicators do not have a green
light, the pairing operation was not done
correctly. Do the procedure again.
9. Push the start/stop button on the remote control and
then turn it clockwise to restart the remote control.
10. Push the start/stop button on the product to restart
the receiver.
To connect the remote control by cable
WARNING: Do not use the remote control
with cable steering where there is a risk that
the product falls on its side. The operator
must be disengaged from the product.
CAUTION: Clean the connector before you
connect the cable. A damaged connector
must be replaced by an approved service
center.
1177 - 001 - 02.04.2020
A
B
1. Connect the cable (A) to the receiver.
2. Connect the cable to the remote control.
To operate the product with the remote control
WARNING: Make sure that you can see the
product at all times when you operate it with
the remote control. The operation range of
the remote control makes it possible to move
the product also when you cannot see it.
Risk of injury and damage.
1. Move the switch for engine speed up, to full throttle.
CAUTION: If you decrease the engine
speed, you must operate the engine at
low speed for 30 seconds before you
increase the speed again.
A
15
Advertisement
