DAF LF45 Series Service Manual page 68

MECHANICAL GEARBOX CONTROL
Inspection and adjustment
6. Fix the gear lever by fitting the special tool
(DAF no. 1329488) over the gear lever and
inserting the end of the gear lever through
the appropriate opening.
2
7. Fit the special tool (DAF no. 1453143)
between the ball joint (1) and the arm (2).
Centre the ball joint (1) by pressing it against
the shoulder of the special tool (A).
Note:
On the special tool (A) (DAF no. 1453143) it
is shown which side of the tool must be used
for LHD vehicles and which side for RHD
vehicles.
8. Hand-tighten the lock nuts (3) of the gearbox
lever without moving the control rod.
9. Tighten the lock nuts (3) on the gearbox lever
to the specified torque without moving the
control rod. See "Technical data".
10. Adjust the length of the torque rod in such a
way that it can be positioned in the control
rod without tension. Tighten the attachment
nut (1) to the specified torque. See
"Technical data".
2-2
DAF LF Gearboxes and Clutch Service Manual
1 2
3
3
ΛΦ45/55 series
V3 00 580
2
A
1
V3 00 840
V3 00 575
©
200508