Specification - Xantrex 42V 10A Operating Manual

OUTPUT
Voltage Range:
Current Range:
Output Voltage Setting:
Output Current Setting:
Operating Mode:
Output Switch:
Output Terminals:
Output Impedance:
Output Protection:
Over-temperature
Protection:
Load & Line Regulation:
Ripple & Noise
(20MHz bandwidth):
Transient Response:
Temperature Coefficient:
Status Indication:
METER SPECIFICATIONS
Meter Types:
Meter Resolutions:
Meter Accuracies:
GENERAL
AC Input:
Power Consumption:
Operating Range:
Storage Range:
Environmental:
Safety:
EMC:
Size:
Weight:
0V to 42V minimum
0A to 10A minimum
By coarse and fine controls.
By single logarithmic control.
Constant voltage or constant current with automatic cross-over.
Electronic. Preset voltage and current displayed when off.
4mm terminals on 19mm (0.75") pitch.
Typically <5mΩ in constant voltage mode.
Typically >20kΩ in constant current mode.
Output will withstand up to 48V forward voltage.
Reverse protection by diode clamp for reverse currents up to 3A.
The output will be tripped off if a fault causes the internal
temperature to rise excessively.
<0.01% of maximum output for a 90% load change or 10% line
change.
Typically <2mVrms, <10mV pk-pk, constant voltage mode.
<200µs to within 50mV of set level for 90% load change.
Typically <100ppm/°C
Output on lamp. Constant current mode lamp.
Dual 4 digit meters with 14mm (0.56") LEDs. Reading rate 4 Hz.
10mV, 10mA
Voltage 0.3% of reading ± 2digit,
Current 0.6% of reading ± 2digit
Factory set for: 110V - 120V AC ±10% or 220V - 240V AC ±10%,
50/60Hz. Installation Category II.
800VA max.
+5ºC to +40ºC, 20% to 80% RH.
−40ºC to + 70ºC.
Indoor use at altitudes up to 2000m, Pollution Degree 2.
Complies with EN61010−1.
Complies with EN61326.
140 x 160 x 320mm (WxHxD).
3.6kg

Specification

3