V-ZUG 731 Installation Instructions

Installation instructions
Oven / Combi-Steam oven
Type of construction 60-600
The appliance should be installed by qualified personnel only. Each step must be carried out and checked in full in the order
specified.
Validity
These installation instructions apply to the models:
Oven: 731, 734, 739, 740, 745, 747, 751, 759, 764, 765
Combi-Steam oven: 771, 796
General notes
If fitting in flammable material, the guidelines and standards for low voltage installations and for the fire protection must be strict-
ly observed.
Identification plate
A
Open appliance door. The identification plate is located on the left trim panel
(see illustration).
Connection plate
A
Pivot connection box downwards. The connection plate is located next to the
connection terminal in the connection box (see «Installation»).
Electrical connections
Electrical connections must be carried out by trained electricians in accordance with the guidelines and standards for low volt-
age installations and the specifications of the local electricity supply companies.
A plug-in appliance may only be connected to a socket outlet with earthing contact, installed according to specifications. A
mains isolating device with 3 mm contact opening should be provided in the house wiring system. Switches, plug and socket
devices, circuit breakers and fusible cut-outs which are accessible after installation and which have all-poles switching are per-
missible as isolating devices. Effective earthing and separately installed neutral and earth conductors ensure safe and fault-
free operation. After installation, live parts and cables with basic insulation must not be accessible. Old installations should al-
ways be checked.
A
Information on the necessary mains voltage, type of current and fuse protection is to be obtained from the identification plate.
1
J731.113-0
1.10.08 ITH