HP 8719D Installation Note page 19

7. New HP-IB commands:
HP-IB Cmd
IFBW3700
SWPSTART
TITP
TITFO
ADAPl[D]
ADPTCOAX
MODS
8. Additional Limit Line and Data Point Functions:
These HPIB-only functions were previously available only with option K96, but have now
been added to the standard firmware set. Example programs using these functions are
available in the Programmer' s Guides with a print date of July 1997 or later.
MINMAX
OUTPAMAX
OUTPAMIN
OUTPSEGAM
OUTPSEGM[n]
SELMAXPT
SELMINPT
OUTPDATP
Installation Note 08720.90372
Description
Set IF Bandwidth to 3700 Hz.
Sweep start (Zrke4).
Raw Offsets (Thke4).
Take4 mode On/off.
Spur Avoidance On/off. HP 8753D (including Option 011) only.
Output "pre-raw" arrays, x= l-4 (l%ke4).
Title Plot to Disk file.
Title the save state filename, only in sequence mode.
Set adapter electrical delay.
Set adapter to COAXial.
Set adapter to WAVEguide.
Compute new cal set using adapter removal.
Recall cal set associated with Port 1 for adapter removal.
Recall cal set associated with Port 2 for adapter removal.
Description
Enable/disable min/max recording per segment. Min and max values
are recorded per limit segment.
Output max values for all limit line segments.
Output min values for all limit line segments.
Output limit test min/max all segments. Output the segment number,
max stimulus, max value, min stimulus, min value for all active
segments.
Output limit test min/max for a specified segment.
Select segment number for the OUTPSEGF and OUTPSEGM
commands to report on.
Select the last point number in the range of points that the
OUTPDATR command will report.
Select the first point number in the range of points that the
OUTPDATR command will report.
Select point number that OUTPDATP will report.
Output trace data indexed by point (see SELPT).
19