HP 8719D Installation Note page 13

If the analyzer displays the message Serial Cor DONE, you have completed this
procedure.
If the analyzer does not display DONE, then either the serial number that you entered in
steps 3 and 4 did not match the required format, or a serial number was already stored.
Check the serial number recognized by the analyzer:
b.
Look for the serial number displayed on the analyzer screen.
c. Rerun this adjustment test.
If the analyzer continues to fail this adjustment routine, contact your nearest HP Sales and
Service Office, listed at
Store the Analyzer Option(s) Information
This procedure stores instrument option(s) information in CPU assembly EEPROMs. You can
also use this procedure to remove a serial number by using the factory supplied keyword, as
referred to in "Store the Analyzer Serial Number."
1.
Press IPreset) IDisplay) MORE TITLE ERASE TITLE
Enter an option keyword (recorded earlier in the section "Remove the Analyzer Rear Panel")
2.
by using an external keyboard, or by rotating the front panel knob to position the arrow
below each character of the keyword, and then pressing SELECT LETTER to enter each
letter.
Press BACKSPACE if you made a mistake.
3.
Press DONE when you have finished entering the title.
Caution
Do not
4. Press (s?) SERVICE MENU TESTS 150) a EXECUTE TEST YES.
Observe the analyzer for the results of the adjustment routine:
If the analyzer has more than one option, repeat steps 2-5 to enter the remaining
n
keyword(s) for options.
If the analyzer displays Option Cor FAIL, check the keyword used in step 3 and make
n
sure it is correct. Pay special attention to the letters "I" or "O", the numbers "1" or "0"
(zero). Repeat this entire adjustment test.
If the analyzer continues to fail the adjustment routine, contact
n
Service Office, listed at the end of this document.
Installation Note 08720.90372
the end of this document.
confuse with "1" or "0" with "0" (zero).
"I"
your nearest
HP Sales and
13