HP 8719D Installation Note page 8

8. Remove the four screws (item 7) that attach the interface bracket to the rear panel.
9. Remove the six screws (item 8) and (item 9), that attach the preregulator to the rear panel.
10. Remove the eight screws (item 10) from the rear frame: four from the top edge and four
from the bottom edge.
11. Remove the screw from the pc board stabilizer and remove the stabilizer.
12. Lift the reference board (A12) from its motherboard connector and disconnect the flexible
RF cable (item 11).
13. Pull the rear panel away from the frame. Disconnect the ribbon cable (item 12) from the
motherboard connector, pressing down and out on the connector locks. Disconnect the
wiring harness (item 13) from the motherboard.
Figure l-l.
Installation Note 08720-9OBpP