Louver Operation; Louver Setting Button; Default Louver Positions - Lennox MS8 Manual

Wireless Remote Functions (Continued)

Louver Operation

LOUVER SETTING button

Use the LOUVER SETTING
button to choose a preferred
setting for the indoor unit
directional louver.
NOTE - Actual louver
position is different than
what is shown on remote
icon. See comparison to
the right.
Press the LOUVER
SETTING button once to
activate the full-range
oscillation mode from top to
bottom, then back again. The
louver icon will appear in
the lower section of the
screen.
Press the LOUVER
SETTING button again to
turn the feature OFF. The
louver will return to the
default setting.
Press the LOUVER
SETTING button twice and
continue to press the button
to scroll through the five
available fixed positions
AND three other oscillating
positions.
LOUVER SETTING button
Use the LOUVER SETTING but­
ton to choose a preferred louver
setting, rather than the default
setting, during fan operation.
Refer to the following section for
louver operation.
TEMP button
Use the TEMP button to change
the temperature display shown
on the remote control. When ini­
tially powered on, the current
temperature setting is displayed,
along with the icon.
Press the TEMP button once
to alter the display to show the
current indoor ambient tempera­
ture, along with the icon. The
indoor temperature sensor is in
the indoor unit.
To return the louver to the
default position, press the
LOUVER SETTING button
until the icon disappears.

Default Louver Positions

When the louver setting icon
is not displayed, the louver is
in the DEFAULT position.
When the remote control is
powered OFF, the default
position is fully closed.
When the remote control is
set so that the unit is in
COOLING, AUTO COOLING,
or DEHUMIDIFICATION
mode, the louver is in a fixed
upward position .
When the remote control is
set so that the unit is in HEAT
or AUTO HEATING mode and
the outdoor unit is OFF, the
louver is fixed in the second
position pointed upward. If
the outdoor unit is ON, the
louver is fixed in a downward
position .
When the remote is set for
continuous indoor fan to be
ON, the louver is fixed in an
upward position .
7
Press the TEMP button again to
display the outdoor ambient tem­
perature icon. The outdoor
ambient temperature display is
not available on this system.
On occasion, the remote control
will display the temperature that
was not selected (indoor ambient
temperature or setting tempera­
ture). The selected temperature
will return to the display screen
after 5 seconds.
NOTE - The TEMP button can
also be used to temporarily dis­
play the indoor ambient tempera­
ture on the indoor unit display
panel.
REMOTE ACTUAL
CONTROL ICON LOUVER
POSITION POSITION
o r a b o v e
LOUVER
SETTING
ICON