Lennox MS8 Manual page 6

Wireless Remote Functions (Continued)
SWITCH FROM °C TO °F
With system OFF, press MODE
and - buttons simultaneously to
switch from Centigrade to
Fahrenheit. Current selection
is displayed to the right of the
temperature display.
CLOCK button
Use the CLOCK button to adjust
the time displayed on the remote
control. Press the CLOCK button
once. The clock icon
flash. Within 2 seconds, use the
- and + buttons to adjust the time
down or up in one-minute incre­
ments. Press the button continu­
ously to adjust the time in
10-minute increments. Press the
CLOCK button again when cor­
rect time is displayed.
BLOW button
Use the BLOW button to
extend low speed blower
operation for 10 minutes
at the end of a cooling
demand.
The extended fan (BLOW)
operation ensures that excess
moisture is removed from the
indoor coil before the blower
shuts off.
Press the BLOW button once to
initiate extended blower opera­
tion. Fan operation ends after 10
minutes.
The extended fan (BLOW)
operation icon is displayed
when the feature is turned on.
Extended fan (BLOW) operation
is available in cooling or dehu­
midification modes; extended fan
(BLOW) operation is not avail­
able in AUTO, heating or fan
mode.
TURBO button
Use the TURBO button to
initiate or cancel high-speed fan
operation to accelerate cooling
or heating of the ambient room
temperature. The turbo icon
is displayed when the function is
turned on.
will
SLEEP button
Use the SLEEP button to initiate
or cancel the sleep function.
Press SLEEP button. When
sleep icon
TIMER OFF button and use -
and + buttons to set time for sys­
tem shutdown. When desired
time is displayed, press TIMER
OFF button again. Press SLEEP
button to cancel sleep function.
In cooling mode, SLEEP function
increases temperature (+1.8°F
per hour) over a two-hour period
after the selected sleep time.
In heating mode, SLEEP function
decreases temperature (-1.8°F
per hour) over a two-hour period
after the selected sleep time.
NOTE - The sleep function is not
available in AUTO or FAN
modes.
TIMER ON button
Use the TIMER ON button to ini­
tiate or cancel a single timed-on
event. Use this feature to bring
the system on just before you re­
turn home or just before you
wake in the morning.
Press the TIMER ON button
once. The clock icon
disappears and a time setting
appears with the word ON flash­
ing at the right. Use the - and +
keys to adjust the time setting to
the desired time for the system
to begin operation. Press the
TIMER ON button again to
accept the setting. When suc­
cessfully set, the word ON will
appear to the right of the current
time display. Press the TIMER
ON button again if you want to
cancel the timed-on event.
TIMER OFF button
Use the TIMER OFF button to
initiate or cancel a single timed-
off event. Use this feature to turn
the system off just after you
leave the house or just after you
go to bed at night.
Use the same method
described above to set the de­
sired time for the system to stop
operation. When successfully
set, the word OFF will appear to
the right of the current time dis­
play. Press the TIMER OFF but­
ton again if you want to cancel
the timed-off event.
appears, press
LIGHT button
Use the LIGHT button to turn the
indoor unit display light on and
off. When the light is on, the
icon appears on the remote con­
trol.
6