Advertisement
3
3
Installing the system in the rack
3.1
3.2
Caution:
between 18 and 32 kg (39.7 and 70.5 lb). It
takes 2 persons to safely lift this part or
18-32 kg (39.7-70.5 lbs)
unit. (C009)
If the N3300 system bezel is attached to the system, carefully remove
the front bezel of the N3300 by pulling out on the rectangular openings
(marked by blue stripes) on either side of the bezel.
From the front of the rack, place the storage system onto the rails and
slide it in until the front mounting bracket of the storage system is a few
inches from the rack frame.
3.2.1
As shown below, at the front of the rack, position the spacer
plates over the locating pins (holes H3 and H4) on the left and
right rails. Slowly slide the chassis into the rack until the front
mounting bracket of the storage system is flush against the
spacer plates.
The weight of this part or unit is
Spacer plate
7
Advertisement
