Polygroup TG76P4751P02 Assembly Instructions

TREE ASSEMBLY INSTRUCTIONS
Congratulations on purchasing your new tree from
Quick Set® technology - it takes less than 10 minutes to set up and light up!
Carefully follow the instructions below on how to quickly and easily set up your new tree:
1. Choose a level surface near a wall outlet.
2. Assemble the tree stand (See Fig. A).
Fig. A - Tree Stand Assembly
Fig. B - Tree and Light Assembly
Section 2
Section 1
3. Identify all tree sections (See Fig. B) by the tags on them, and start assembling from bottom to top.
4. Open the protective cap of pole, and insert the pole into the stand. Allow all branches fall down into
place. Check to make sure that all wires are free from branch hinges.
5. Shape the tree section one branch at a time. Start with the tips closest to the pole and move outwards.
Fan all the tips out in alternating directions, and slightly upsweep them for a natural look (See Fig. C).
Fig. C
Top view
6. Repeat Step 4 and 5 for the upper tree section(s) until tree top is installed and shaped.
7. Connect plug with adaptor, and plug it in to the wall outlet as indicated in Fig. B. Your tree should now
be lit. If not, please see TROUBLESHOOTING TIPS.
8. Step back and view your tree. Shift branches to fill any gaps. Your Christmas tree is now ready to be
decorated.
MODEL #: TG76P4751P02
Polygroup®!
Tree Top
Side view
This tree comes with
Unfold tree stand legs. Then
slide the locking disc down
until it snaps into place.
*Electrical Rating For The Tree
(For Indoor Use Only)
Input: 120V, 60Hz, 0.83A
Output: 24V DC 2A
Do Not Tamper
Internal Parts
Open the
protective
cap
Do Not Tamper
Internal Parts
Open the
protective
cap
Plug Adaptor
Into Wall
Outlet
Insert Green Label
Plug into Adaptor
1
Please scan code to
learn how to shape
and set up your tree