Polygroup Evergreen Classics TG76P4A73D06 Quick Start Manual

WE ARE HERE TO HELP!
DO NOT RETURN TO STORE. PLEASE VISIT US AT:
www.polygroupstore.com OR 1-888-919-0070
Thank you for purchasing your Smart Tree from Polygroup®! This tree is very innovative, as you can voice control all the lighting
effects via Amazon Alexa or Google Home. The tree itself also comes with Quick Set® technology - allowing you to set up your
tree and light it up in minutes! The instructions below will help you easily set up your new tree.

ASSEMBLY INSTRUCTIONS

1. Find a flat, level surface near an electrical outlet and assemble the tree stand as shown in Fig. A.
Fig. A - Tree Stand Assembly
Fig. B - Tree and Light Assembly
Section 1
2. Each tree section is numbered with a sticker. Identify all sections before assembling.
3. Assemble the tree from the bottom to the top (see Fig. B). Open the protective cap on the lower pole, then insert the upper pole
until firmly secured.
* It is easier to check the pole connectivity and shape the branches, section by section.
4. For pre-lit trees, plug the power cord/adapter into the wall outlet. Tree Section 1 should be lit instantly. If it is not, or if some bulbs
do not light or begin to flicker, see TROUBLESHOOTING TIPS to fix it before moving on to the upper section.
5. For shaping, allow branches to fall into place or gently pull upwards and outwards; make sure
that all wires are free of branch hinges. Always start with the lowest tips closest to the pole;
pull the individual tips alternately upwards and outwards (see Fig. C) and work your way to
the tip of the branch. Continue to work row by row until the top row of the section is shaped.
6. Repeat Step 3-5 until the tree top is installed. Your tree is now ready to be decorated.
Tree Top
Section 2
Unfold the legs and lay the stand in
a flat area. Then slide the locking disc
downward and snap into place.
Do Not Tamper
Internal Parts
Open the
cap cover
Align both arrows in
a straight line before
sliding down to insert
Light
Controller
1
CAUTION! For indoor use only
* Electrical Rating For The Tree
Input: 120V, 60Hz, 0.25A
Output: DC 29V, 0.45A
Adapter
to be plugged
into wall
outlet