Initial Operation - eisenblatter PIPE MAX 802 HT Original Instructions Manual

- Vacuum or wash protective clothing Do not blow, beat or
brush.

5. Initial Operation

5.1 Connection to Power Mains
Before commissioning, check that the rated
mains voltage and mains frequency, as stated
on the type plate match your power supply.
Always install an RCD with a maximum trip
current of 30 mA upstream.
The red electronics signal indicator lights up briefly when
the mains plug is inserted in the socket, indicating
readiness for operation.
5.2 Setting speed
The speed can be preset via the thumb-wheel and is
infinitely variable.
Engine speed (rpm) 820 - 3.000
Power Stage 1
Power Stage 2
Power Stage 3
Power Stage 4
Power Stage 5
Power Stage 6
The VTC electronics make material-compatible
work possible and an almost constant speed, even
under load. The best way to determine the ideal speed
setting is by performing a test.
6. Switching on and off
Always guide the machine with both hands.
Switch on first, then guide the accessory
towards the workpiece.
The machine must not be allowed to draw in
additional dust and shavings. When switching
the machine on and off, keep it away from dust
deposits. After switching off the machine, only
place it down when the motor has come to a
standstill.
In continuous operation, the machine
continues running if it is forced out of your
hands. Therefore, always hold the machine with
both hands using the handles provided, stand
securely and concentrate.
14
820
1.250
1.700
2.150
2.600
3.000
Torque activation (with dead man's lever)
9
I
Switching on: Slide the trigger switch (9)
forwards and then push the trigger switch
(9) upwards.
Switching off: Release the trigger switch (9).
Continuous operation
9
I
Switching on: Switch the machine on as described
above. Now slide the trigger switch (9) forwards again and
release in the front position to lock the trigger switch (9)
(continuous operation).
Switching off: Push the trigger switch (9) upwards and
release.
7. Attaching the tools, working notes
Press in the spindle locking knob only when the
spindle is stationary!
7.1 Tools for tensioning:
Push the grinding belt onto the belt guide roller and pull
it towards the drive roller. Then guide the abrasives above
the drive roller and tension the absorber.
7.2 Working Directions
Sanding and polishing:
Apply the running machine with moderate pressure on the
working area of your pipe/workpiece.
The shock absorber closes automatically the lift arm with
rising pressure and encloces the workpiece.
For perfect transitions in industrial grinding or mirror finis-
hing ensure working vertically (90° to the pipe/workpiece).
To work on surface areas put only the contact wheel in
45° angle on the workpiece and proceed like a linear
grinding machine, instead of putting the middle of the belt
between drive roller and contact wheel.
Pay attention to the maximum rotational speed of your
application tools.
0
0
EN