Advertisement
BATTERY REMOVAL AND INSTALLATION INSTRUCTIONS
HOW TO INSTALL BATTERIES
1. Push latch and lift door on bottom of the Air Patroller™ to reveal battery door. 2. Open the battery door
with a screwdriver (not included). 3. If used batteries are present, remove these batteries from the unit by
pulling up on one end of each battery. DO NOT remove or install batteries using sharp or metal tools.
4. Install new batteries as shown in the polarity diagram (+/-) inside the battery compartment. 5. Replace
battery door securely. 6. Check your local laws and regulations for correct recycling and/or battery disposal.
NOTE: Always use fresh, premium quality batteries.
a WARNING: KEEP BATTERIES OUT OF REACH OF CHILDREN. This
product contains a Button or Coin Cell Battery. A swallowed Button or
Coin Cell Battery can cause internal chemical burns in as little as two
hours and lead to death due to chemical burns and potential
perforation of the esophagus. Dispose of used batteries immediately
and safely. Used batteries can still be dangerous. Keep new and
used batteries away from children. If you think batteries might have
been swallowed or placed inside any part of the body, seek
immediate medical attention.
2
Press button for
1
lights and sounds.
Change jet sounds to
2
helicopter sounds by
rotating engine as shown.
Cockpit and cargo bay
3
door open.
3
Advertisement
