Download Print this page
Spin Master PLUSH POWER POLICE CAR Instruction Manual
Spin Master PLUSH POWER POLICE CAR Instruction Manual

Spin Master PLUSH POWER POLICE CAR Instruction Manual

Advertisement

Quick Links

Drive/Forward
Rouler/avancer
Marche arrière/tourner
Easy to follow instruction videos:
Instructions vidéo faciles à suivre :

How to Install Batteries

1. Open the battery door with a
screwdriver.
2. If used batteries are present, remove
these batteries from the unit by pulling up
on one end of each battery. DO NOT
remove or install batteries using sharp or
metal tools.
3. Install new batteries as shown in the
polarity diagram (+/-) inside the battery
compartment.
4. Replace battery door securely.
5. Check your local laws and regulations
for correct recycling and/or battery
disposal.
How to Connect Your Controller
To connect the controller and vehicle, first place batteries in the vehicle. Then
place batteries in the controller. Turn the vehicle on and press any button on the
controller.
How to Drive / Conduite
1. Move the power switch to the ON position and place the vehicle on
a smooth flat surface.
1. Mettre l'interrupteur en position ON et poser le véhicule sur une
surface plane et lisse.
Note: For best performance, drive on hard wood, tile, and other low-trim surfaces. Always avoid water or wet areas.
Remarque : Pour des performances optimales, faire rouler le véhicule sur du plancher, du carrelage ou autres surfaces rases.
CAUTION:
a
HAIR ENTANGLEMENT —
Tie back and cover hair and secure
loose clothing prior to play.
Reverse/Turn
1
Ne pas faire rouler dans l'eau ou dans des zones humides.
MISE EN GARDE :
a
LES CHEVEUX PEUVENT SE COINCER —
Attacher les cheveux et les couvrir, et
maintenir les vêtements amples à l'écart du jouet.
CONTENTS:
e
1 Plush Power™ Police Car, 1 Controller, 1 Instruction Guide.
CONTENU :
f
1 voiture de police Plush Power™, 1 radiocommande, 1 mode d'emploi.
POLICE CAR
Battery Compartment
Compartiment des piles
On / Off Switch
Interrupteur ON/OFF
Connexion de la radiocommande
Pour connecter la radiocommande au véhicule, insérer d'abord les piles dans le
véhicule. Puis, insérer les piles dans la radiocommande. Allumer le véhicule et
appuyer sur n'importe quel bouton de la radiocommande.
2. Press the forward button on the controller
to drive forward.
2. Appuyer sur le bouton Avancer de la
radiocommande pour faire avancer le
véhicule.
INDOOR USE
ONLY
UTILISATION
EN INTÉRIEUR
UNIQUEMENT
Installation des piles
1. À l'aide d'un tournevis, ouvrir le
couvercle du compartiment des piles.
2. Si des piles usagées sont présentes, les
extraire en tirant sur l'une des extrémités.
NE PAS utiliser d'objet coupant ou
métallique pour extraire ou installer les
piles.
3. Installer des piles neuves comme
indiqué sur le schéma de polarité (+/-) du
compartiment des piles.
4. Bien refermer le compartiment des piles.
5. Consulter la législation locale concernant
le recyclage et/ou l'élimination des piles.
2
3. To reverse and turn, press the reverse button
and the vehicle will reverse turn.
3. Pour reculer et tourner, appuyer sur le
bouton Marche arrière et le véhicule effectuera
une marche arrière en tournant.
5
AAA
LR03
(
x
1.5 V / 1,5 V
NOT INCLUDED • NON FOURNIES
3+
YRS
Ans
3
8+
)
YRS

Advertisement

loading

Summary of Contents for Spin Master PLUSH POWER POLICE CAR

  • Page 1: How To Install Batteries

    CONTENTS: 1 Plush Power™ Police Car, 1 Controller, 1 Instruction Guide. CONTENU : 1 voiture de police Plush Power™, 1 radiocommande, 1 mode d’emploi. POLICE CAR Battery Compartment Compartiment des piles Drive/Forward Reverse/Turn Rouler/avancer Marche arrière/tourner On / Off Switch Interrupteur ON/OFF Easy to follow instruction videos: Instructions vidéo faciles à...
  • Page 2: Troubleshooting

    (cristal, semi-conducteur, etc.), pourrait constituer une 95 and must be expressly approved by Spin Master Ltd or they could void the user’s authority to operate the violation de l'article 15 et/ou 95 de la réglementation de la FCC, et doit être expressément approuvé par Spin equipment.