Page 1
3A0020B For use with two horizontally mounted proportioning pumps. For professional use only. Not for use in explosive atmospheres. 258771 - Horizontal Hydraulic Driver 1200 psi (8.2 MPa, 82.7 bar) Maximum Working Pressure Important Safety Instructions Read all warnings and instructions in this manual and all supplied manuals.
2. Use two people to lift and clamp the cylinder (1) in a Recommended Hydraulic Oil vise. Use Graco-approved Hydraulic Oil, Part No. 169236 NOTICE (5 gal) or 207428 (1 gal)) or a premium, ISO grade 46 petroleum-based hydraulic oil containing rust and To prevent damage to sealing surfaces, do not oxidation inhibitors and anti-wear agents.
Repair Assembly NOTE: Be careful not to damage piston rod assem Residual hydraulic oil in the cylinder can spray out of bly (9). ports during removal of the piston assembly. 1. Clamp piston rod (9) flats or hex in a vise to prevent damage to the piston rod.
Page 5
Repair 5. Lubricate inside of cylinder (1) with hydraulic oil to 9. Install second seal housing (2) on cylinder (1). allow easy installation of piston assembly. Continue Torque to 150-160 ft-lbs (203-216 N•m). to next step if the cylinder hasn’t been flushed and NOTE: Use a rubber mallet to gently tap seal hous there is residual hydraulic oil.
Dimensions Dimensions 17.375 in. r_258640_3A0020A_14h (441.3 mm) Mounting Hole Layout r_258640_3A0020A_15h r_258640_3A0020A_17h 6.165 in. (156.6 mm) 5.114 in. (129.9 mm) 6.5 in. (165.1 mm) 4.43 in. (112.5 mm) 5.906 in. (150 mm) 120° bolt circle 6.26 in. (159.0 mm) 4 in. (101.6 mm) 3A0020B...
Technical Data Technical Data Maximum hydraulic working pressure ....1200 psi (8.3 MPa, 83 bar) Maximum fluid temperature ..... . . 160°F (71°C) Maximum hydraulic fluid flow .
With the exception of any special, extended, or limited warranty published by Graco, Graco will, for a period of twelve months from the date of sale, repair or replace any part of the equipment determined by Graco to be defective.