Maintenance; Cleaning And Decontamination Instructions; Spare Parts - Greiner Bio-One Sed Rate Timer 10/II User Manual

9. MAINTENANCE

The instrument does not require a maintenance under normal user conditions, but a
preventive maintenance can reduce a spontaneous instrument failure. Please pay attention
to the cleanliness of the upper part (test tube positioning plate), which must be covered when
the instrument is not used. Do not clean the upper plate with liquids or damp cloths. The
entry of liquids or solid material into the reading channels can cause considerable damage to
the instrument.

9.1 Cleaning and decontamination instructions

Dust can be removed using an ordinary vacuum cleaner. Pay particular attention to the test
tube: it must be well closed and the cap should not be never removed. The label must be
correctly positioned and well stuck to the test tube surface. Label fragments could fall into
the test channel and obstruct a correct reading function during analysis.
1. Wipe potentially contaminated areas of the SRT 10/II with a cloth or paper towel wet
with 1% bleach solution (Solution A). Solution A (about 1%): 200 ml hypochloride
and 800 ml of reagent grade water.
2. Let solution set for at least 15 minutes.
3. Wipe Solution A from areas.
4. Wipe areas again with cloth or paper towel with reagent grade water to remove the
Solution A.
5. Dry areas thoroughly.

9.2 Spare parts

SAP
SED RATE TIMER 10/II - SPARE PARTS LIST
Code
Description
ESR-Spare part SEM30-001 Fan
836250
for SRT 10/II, MultiMixer
12 Vdc; 40x40x10
ESR-Spare part ELE10-029
Power supply (Voltage 12 Vdc) for:
836256
- SRT 10 & SRT 10/II
- MultiMixer
836582
Thermal Printer for SRT 10/II
836585 Thermal Paper for printer 836582
836588 ESR control unit for SRT 10/II, SRS 20/II, SRS 100/II
IMB40-030 Dust cover SRT10/II
WARNING: in order to assure the safety and performance of the instrument do not
use other spare parts than the ones specified above.
SRT 10/II USER MANUAL page 24 of 37