Greiner Bio-One Sed Rate Timer 10/II User Manual page 11

3.4 Power on
The cable that connects the instrument to the electrical circuit is the most important system of
disconnection from the electrical source. For this reason, the cable must be easily reached
and accessible by the user.
Connect power supply outlet to the instrument. Insert the power supply plug in a socket with
an earth connection.
If the instrument has an optional printer it should be connected to the SRT 10/II with the
appropriate cable and plugged in.
Connect and switch on first the printer, then the SRT 10/II using the switch situated at the
rear of the instrument.
Each time SRT 10/II is switched on, it carries out an electronic initialization and an instrument
check test.
then configuration data appears (dependant on the switch settings defined in chapter 3.3
If the printer has been connected, this message will be also printed, followed by the
header of the results given at the end of each analysis.
SRT 10/II
On the display appears this message:
greiner Bio-One
SRT10/II V.1.1
Configuration):
15' working time
results: mm/1h
30' working time
results: mm/30', mm/1h
60' working time
results: mm/30', mm/1h, mm/2h
USER MANUAL page 11 of 37