Connection To An Access Control System - Olivetti FL X1 User Manual

2.4 CONNECTION TO AN ACCESS CONTROL SYSTEM

The Olivetti FL X1 can be used to enable/disable the automatic access control system (eg turnstile;
automatic door; automatic bar, etc), through a specific connection to the access control system.
N.B.: to ensure a correct interaction between the Olivetti FL X1 device and the access control
system, we recommend you to consult your access control system installer.
To connect the FL X1 and the access control system, use the Digital Output interface, by
connecting the related KZ_Out connector (included in the multiple connector cable, see par. 1.2)
to the corresponding interface/pair of trigger wires for triggering the gate to open.
The access control system will be normally set in Gate Closed mode and it will be enabled to allow
a person's access only when the FL X1 will send the trigger signal, i.e. when the termoscanner will
test successfully the personnel temperature and the presence of the mask. In this case, the internal
switch of the FL X1 will close the electrical circuit and send to the access control system the
impulse to unblock the access (eg turnstile; automatic door; automatic bar, etc).
The system operation is summarized in the following page.
For the Olivetti FL X1 setting related to the Access Control functionality, see par. 2.3.4
FL X1 User Manual 22